Winter
February punch list: find the leaks, then line up spring work
Ten jobs for late winter: the attic, the drafts, the cracks that froze and the bids you should start collecting now.
By RoofElm Editorial Team Updated 5 min read
- Main job
- Attic and air leaks
- Roof access
- Ground level only
- Planning task
- Collect spring bids
- Tools needed
- Flashlight, tape, phone
In short
February is when winter damage becomes visible and spring schedules fill up. Check the attic for moisture, find the air leaks that feed ice at the eaves, and look at what freezing did to the driveway, fence and gate hardware. Then start asking contractors for bids, because the good slots go early. Compare them with the estimate reading guide.
What February is for
By February the house has been through weeks of cold, and the weak spots have had time to show. Ice that keeps coming back at the same eave, a ceiling stain that grows after each thaw and a door you have to lean on to close are all clues. Write them down while they are fresh.
This is also the month to plan. Roofers, window crews and fence builders get busy once the weather warms. Asking for bids now, for work in spring, gives you time to compare scope line by line and check licenses and insurance without a rush.
The February punch list
- Go back into the attic with a flashlight and look at the roof deck and the insulation. Dark patches on the wood, wet or matted insulation and rusty nail tips are moisture signs. Photograph them with a date.
- Check that the attic vents are not blocked. Look at the soffit vents at the low edge and any ridge vent at the top, and make sure insulation has not been pushed over them.
- Find air leaks from the living space into the attic: around the hatch, ceiling light housings, plumbing and wire holes, and the top of interior walls. Mark each one with tape for later sealing.
- Check ceilings and the tops of exterior walls inside the house for new stains, bubbled paint or a damp smell.
- From the ground, look again at the eaves and gutters after each thaw. Note any section that stays iced over or has pulled loose, and any spot where water runs down the wall instead of into the downspout.
- Test every exterior door. Close it on a strip of paper at the top, sides and bottom; if the paper slides out easily, the weatherstripping or threshold needs work.
- Look at window frames from outside and inside for failed caulk, soft wood or fogging between the panes of double glazing.
- Walk the fence line and push on posts. Mark any that lean or move, and check gate latches and hinges that froze and sagged.
- Look at the driveway for new cracks, spalling or settled edges. Mark them with chalk and photograph them, because freeze and thaw widens small cracks.
- Ask two or three contractors for written bids on any job from your list. Give each the same scope so the prices can be compared, and ask for the license number and insurance certificate.
February by region
| Task | Cold | Hot-humid | Dry West |
|---|---|---|---|
| Attic moisture | Frost and wet insulation point to warm air leaking up. | Damp insulation and mildew point to humid air and leaks. | Dry attics hide stains; look at the nail tips and deck. |
| Air leaks | Seal first; ice at the eaves often starts with heat loss. | Seal around ducts and the hatch to keep damp air out. | Seal gaps that let in dust and temperature swings. |
| Doors and windows | Check seals and thresholds against drafts. | Check for swelling, rot at the sill and failed caulk. | Check sun damage on finishes and brittle seals. |
| Driveway and fence | Mark frost cracks and leaning posts. | Mark soft spots and wet-ground settling. | Mark cracks that let in rain and runoff. |
Safety in late winter
Related jobs and the newsletter
To size the attic fix, use the attic insulation gap calculator and read attic insulation and air sealing. Before you call anyone for a bid, read how to hire a licensed contractor. Weatherization help in your state is listed on the state help pages. Next up is the March punch list, and the weekly newsletter sends each month's list ahead of time.
Common questions
Should I get roof bids in February?
Yes, if you are thinking about spring work. Ask each roofer to bid the same scope, and read roof replacement first so you know what the bid should list.
How do I tell frost in the attic from a roof leak?
Frost that melts into drips on a warm day usually comes from indoor air reaching the cold deck. A leak shows as a stain around a penetration, valley or flashing. Both deserve a photo and a pro's opinion if you are unsure.
Can I seal attic air leaks myself?
Many are a homeowner job, but keep insulation away from heat sources and do not seal around flues and chimneys without checking the rules. Ask a pro if you are not sure.
Sources
- NDSU Extension: Reduce ice dam and icicle damage
- Pacific Northwest National Laboratory: Ice dam prevention
- CPSC: Ladders and Electricity Don't Mix
Reference pages listed on November 19, 2026, for further reading. This page gives no dated rule or figure from them. Read the ladder and power line sheet in full before any outdoor work.
Next on the job
-
Project
Attic insulation and air sealing
Seal first, then insulate: ENERGY STAR R-values by zone, vent math and safety stop signs.
-
Project
Entry and garage doors
Prehung or slab, measuring the opening, seals, garage door springs and what a bid should say.
-
Guide
Hire a licensed contractor
Check the license, the insurance and the permit plan before you sign. Licensing is state law.